Changing the Coolant Through Filter - CNCzone.com-The Largest Machinist Community on the net!

donl517 · #1 09-17-2007, 01:16 PM

I can't find any info in the book and I don't want to break it. I assume it screws together; I can't make it budge. Can someone elaborate on how to open this up?

Thanks,
Don

donl517 · #2 09-18-2007, 09:52 AM

Anybody???

IN2GLAMISGIRL · #3 09-18-2007, 11:15 AM

The filter can is held on to the housing with a draw bar. The nut is on the back side of the casting. I change the filter every time I clean the sump. It is a standard string wound filter. A few bucks each from McMaster carr.

donl517 · #4 09-18-2007, 05:31 PM

Thanks a million! That was what I needed. Mine is mounted vertical so the nut was on top; but at least I was able to get it open.

Don

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Filter Question	totalfab06	CNC Plasma and Waterjet Machines	1	03-09-2007 07:02 PM
arc and nurb filter	camtd	Surfcam	1	07-25-2006 07:48 AM
Self cleaning Filter	Rance	DIY-CNC Router Table Machines	5	01-18-2006 11:58 AM
Calculating Filter Capacitance	CapnC	General Electronics Discussion	5	01-04-2005 06:40 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)