| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fadal Discuss Fadal machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-05-2007, 08:47 PM
| |||
| |||
Our Fadal 4020 will E-stop with an Z amp alarm during a run. It stops then slowly drops to the table in the same place every time, X=0.182 Y=16.208. Servose are DC. Swapped Z&Y cards, n.g. Any suggestions? VIP  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Now I get a "197 C-AXIS COMMANDED IN SPINDLE MODE" ALARM | theemudracer | Fanuc | 14 | 01-07-2007 11:10 PM |
| Macro alarm "009 ILLEGAL ADDRESS INPUT" | theemudracer | Fanuc | 7 | 12-26-2006 09:57 AM |
| alarm "2013 AITL OFF" Hamai/FS-6M | Nat | Machine Problems, Solutions , Wireless DNC, serial port | 0 | 07-02-2006 07:55 PM |
| ALARM!!! "Commanded X Axis move too far / Positive" | aimeahz | Bridgeport and Hardinge Mills | 6 | 04-20-2006 05:51 PM |
| | |
"Z" axis amp alarm 
Linear Mode
