| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fadal Discuss Fadal machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-28-2007, 11:58 AM
| |||
| |||
Fadal VMC 6030 CNC88HS. Powered up, select 'Jog', amplifier fault message on whatever axis I select. Power down, hooked a jumper on the 1100-1b board,right side of fuses, between 12 and 16 to bypass stop condition. Powered up, 'Jog', select Z and move, select Y and move, select X and 'amplifier fault X axis. Swap axis cards, no change. Had motor rebuilt ($$) no change.  |
|
#2
09-06-2007, 10:43 AM
| |||
| |||
| The amp that had initially tested good, now proved to be defective. Replaced it (X axis), and with the rebuilt motor, and alarms were cleared, all axis functional. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| fadal servo amplifier fault | bala955 | Fadal | 14 | 10-13-2008 02:09 PM |
| Z axis Amplifier Fault on Fadal 4020 | Fudd | Fadal | 2 | 08-29-2006 05:01 PM |
| Z Axis Drive Fault | jeremy_d | Servo Motors and Drives | 2 | 08-15-2006 10:04 PM |
| C axis fault | Rudee | Fadal | 3 | 05-13-2005 11:58 AM |
| Axis Drive Fault | Bluey | Machine Problems, Solutions , Wireless DNC, serial port | 3 | 11-03-2004 06:54 PM |
| | |
Linear Mode
