Squeaking belts!!!

[A+ Machining]

I have a 2001 VMC3020, my low range belt is driving me crazy! Some days its not to bad but other days I can't here myself think.
I bought a new set of belts but I heard somewhere that the motor mounts also can cause the sqeaking?
Has anyone had this problem?

Thanks
A+

[IN2GLAMISGIRL]

Seems to always happen in low range. Ckeck your pulleys for a build-up of dried coolant/oil in the bottom of the vvvvvvvvv. I clean it out with MEK and a fine S.S. welders brush. Also on new belts the paint marking sometimes makes a squeek when it goes by the idler, you can scotch-brite that off.

[gaswiz69]

Yes motor mounts can cause noise. Just check the motor mounts to see if rubber is squishing out of the sides, if so, it's time to replace them.

[rweller]

Hasn't FADAL changed the coolant seal on thru-coolant machines to reduce coolant-on-belt problem (slip/squeek)?

[IN2GLAMISGIRL]

Fadal did change the coolant thru seal system. I have a 2007 3020 with air lines going to the seal system. I have not pulled the cover off to see what is different. I does have a timer relay that stops the seal air flow about 5 sec. after the coolant is shut off.