I need a replacement keyboard Key - CNCzone.com-The Largest Machinist Community on the net!

donl517 · #1 06-08-2007, 02:52 PM

Anybody out there have an old keyboard for a Fadal CNC88? I need the black plastic piece from the back of a key.

Thanks,
Don

donl517 · #2 06-13-2007, 05:07 PM

As it turns out, now that the machine is here, the key is not repairable after all.

Thanks Anyway,
Don

Surfacefeet · #3 06-14-2007, 03:54 AM

Don, You'll have to most likely get a new keyboard from Fadal but you can ask them if you can just get the one key.Never hurts to ask.

donl517 · #4 06-14-2007, 05:52 AM

Well I was able to repair it after all. I glued the back piece back on the board. It seems to work fine. Time will tell.

Thanks,
Don

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
keyboard hacking	dertsap	General Electronics Discussion	20	12-08-2009 09:11 AM
Replacement Keyboard for Biesse NC410?	southcoast	CNC Machining Centers	9	11-11-2006 02:10 AM
Keyboard stopped working??	honk	Autodesk Software (Autocad, Inventor etc)	1	10-24-2006 06:16 PM
How do I keep the chips out of my keyboard?	widgitmaster	DIY-CNC Router Table Machines	25	11-30-2005 04:37 PM
keyboard jog	HuFlungDung	CamSoft Products	26	06-08-2004 09:17 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)