| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fadal Discuss Fadal machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-28-2007, 12:42 AM
| |||
| |||
Tomorrow morning I have to take the spindle motor off a 89' VMC 40. Fadal just installed a 6 to 2 belt conversion kit for me and during the install he discovered a during an earlier repair a tech stripped both mounting bolts in the motor. I just need lift it enough for clearance to install a helicoil on both sides. The plan is to support the motor on the sheet metal on either side then Z- untill i have the room to work. I am sure this will be really easy right up to the point I start. Any pointers would be greatly appreciated. RJ    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| more rpms for spindle motor and spindle | bob1112 | Mechanical Calculations/Engineering Design | 33 | 02-10-2007 02:01 PM |
| R8 spindle pin removal | krymis | Industrial Hobbies (Support forum) | 37 | 01-08-2007 08:42 AM |
| spindle motor | Yint | Mechanical Calculations/Engineering Design | 0 | 10-13-2006 10:35 AM |
| DC Spindle motor | Phooey | Bridgeport and Hardinge Mills | 9 | 09-26-2005 01:02 AM |
| Spindle motor | TommyB | DIY-CNC Router Table Machines | 1 | 12-08-2004 11:11 AM |
| | |
Linear Mode
