"CHIRP" at tool change

[FADALDMU50]

Hi guys
Im sure someone has experienced this.
When my Fadal goes to a tool change it makes a high pitch chirp.
It seems to do it when the tool clamps
I have taken the tool out and just manually press and depress the Tool in / out button and it makes this chirp.
Look forward to your reply

Similar Threads:

• Need Help!- morbidelli/ author 667 "PLC30 Cycle Tool Change"
• Problem- Blue screen tool change macro "off"
• Fanuc 11m alarm "EX25 Machine Stop" in the middle of tool change
• modify post to add "next tool" variable after every tool change
• Build Thread- For Syntec system: how to change "mm" into imperial units "inch"

[slowlearner]

Kinda sounds like the muffler has been removed from the valve on the drawbar assembly.

[rodney247]

Sounds like it is the Muffler on the tool in/out piston. if the muffler was removed it sounds like a .22 caliber revolver being shot

[FADALDMU50]

Thanks for the help.
I have a new muffler on order..

Cheers

- - - Updated - - -

Thanks for the help....

[FADALDMU50]

Ended up being the input air pressure was "TOO MUCH"
Running fine as I have lowered it to 80-90
Thanks again