| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fadal Discuss Fadal machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
03-09-2007, 12:04 PM
| |||
| |||
| Do you have a door interlock problem?    |
|
#3
03-09-2007, 01:36 PM
| ||||
| ||||
| If it is the "EXT HOLD" message that is coming up, then you door interlock switch ing breaking contact. Perhaps the doors have vibrated open some or are mis-aligned. If the missage is "SLide HOLD" then perhaps you have a shorting wire of bad hold switch. Neal |
|
#4
03-10-2007, 08:55 AM
| |||
| |||
| I don't have the door interlock connected. It has run for about 6 months like this without any issues. And unfortunatly I dont get an error message of any kind the machine just goes into slide hold. spindle stays running. All i do is hit START and it continues as normal. ????? thanks for the replies. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How do you get a hold of one cnc? | turboboy | OneCNC | 8 | 01-03-2007 07:50 AM |
| Using a non-Fadal Rotary Table With a Fadal VMC | Fudd | Fadal | 4 | 03-01-2006 10:46 PM |
| What should Feed Hold actually be?? | REVCAM_Bob | Servo Motors and Drives | 4 | 01-22-2006 01:04 PM |
| How to hold | MIKEB | Work Fixtures and Hold-Down Solutions | 12 | 09-04-2005 09:50 PM |
| What do you use to hold your work down? | CNCadmin | Work Fixtures and Hold-Down Solutions | 2 | 06-03-2005 11:27 AM |
| | |
Linear Mode
