Reply with QuoteFadal used AMC amps with Baldor motors also. If your motors jived with your amps and your amps jived with the axis controller cards then I guess you could do it. Glentek stuff getting hard to get? Why do you want to do that?
Fadal Control Support DC to AC Servos
Is it possible to replace the Glentek / AMP DC servos and drives with third party AC servos and still use the Fadal control?
Similar Threads:
Re: Fadal Control Support DC to AC Servos
Fadal used AMC amps with Baldor motors also. If your motors jived with your amps and your amps jived with the axis controller cards then I guess you could do it. Glentek stuff getting hard to get? Why do you want to do that?
Re: Fadal Control Support DC to AC Servos
You sure can BUT the DC motors are very long and have very high torque, tach, resolver. You can get AC and DC Fadal motors everywhere.
We have had good luck with our Fadals milling mostly soft steel and aluminum up to 5 axis. We are always looking for spare parts :) If you have a broken down Fadal give a shout.
for convert to ac motor Do i need change u15 and u18 eeproms on controler cards??Originally Posted by carbidecraters
Re: Fadal Control Support DC to AC Servos
...Hi Mhook,
which type cards to you have? and machine...NUMBERS
Last edited by machinehop5; 01-22-2021 at 05:31 AM.
hi
my machine :
fadal 4020 1996 dc motor
and 1010-5a cards with
1400-5A cpu
Re: Fadal Control Support DC to AC Servos
Yes you need AC eproms with the correct software if you have 1010-5 or-6
thx
