Beacon light on a VMC40 not working

[icentropy]

Hi all, simple question really. Do you guys know if there's a fuse or relay for the beacon light on a VMC40? Mine's not working, I doubt there's a switch or setting for it so figure probably just a fuse or....?

Similar Threads:

• Enclosure light not working - Puma 230ms
• Light Machines, Spectralight CNC lathe, tooling, manuals, working computer
• End Of Cycle / PATO Beacon Lamps
• Beacon Light
• re;g203v red light on axis not working

[rodney247]

The Relay for the "Blue Light" Beacon is located in the Pendant position K1 information this document page 72 http://itscnc.com/images/Pendant_1.pdf

[icentropy]

Thanks, I couldn't figure out the doc but I kept looking around in the pendant and finally saw the empty relay holes in that small board. Someone must have needed the relay in the past and left it off. Working good now. I want to add a audible buzzer or alarm to the beacon and wanted to make sure it worked before going any further. Now I just need to find some sort of 120V buzzer with a volume adjustment