Need Help! VMC 15 XT won't edit program


Results 1 to 3 of 3

Thread: VMC 15 XT won't edit program

  1. #1
    Registered
    Join Date
    Apr 2017
    Location
    United States
    Posts
    0
    Downloads
    0
    Uploads
    0

    Default VMC 15 XT won't edit program

    We have a Fadal VMC 15-XT with a 88HS control. We are not able to edit programs on the machine. We checked the keylock switch and it is good. Any time we need to edit a program, we have to do it on the PC and then send it back over to the machine. The function of the machine is good, but nobody wants to use it as it is a bear to setup.
    I am told that there is a parameter that will unlock the machine, but the ability to go into the parameters is locked out as well. Is there an unlock code we can use to fix this?

    I'm told it's been this way for years. I just started here and I'd like to use the machine with editing enabled.

    Thanks in advance,

    Scott in Terre Haute IN

    Similar Threads:


  2. #2
    Member
    Join Date
    Jun 2016
    Location
    United States
    Posts
    57
    Downloads
    0
    Uploads
    0

    Default Re: VMC 15 XT won't edit program

    Check the wiring to the keylock switch. It may have been disconnected at some time...



  3. #3

    Default Re: VMC 15 XT won't edit program

    It is a combination of the Keylock (which you said is good) and the CL command SETP goes to the parameters



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

VMC 15 XT won't edit program

VMC 15 XT won't edit program