Fadal AFF feed forward question


Results 1 to 1 of 1

Thread: Fadal AFF feed forward question

  1. #1
    Registered
    Join Date
    Aug 2009
    Location
    HUNGARY
    Posts
    12
    Downloads
    0
    Uploads
    0

    Default Fadal AFF feed forward question

    Hi

    I have sys 103.5 software verion on my 1996 year vmc15 xt machine , and i would like to use AFF function.
    I dont have yet the pcb-0191 board in but i am able to invest for that 1k card if the AFF solved my problem,
    We use Seco high feed milling tools (diameter 50mm) with 0.4mm deep cutt on feed speed 7000mm\min.
    the machine running fine just on the corner bumping. toolpath sometimes 90 degrees sharp corner.
    I am not sure AFF will reduce the speed before the tool turn 90degreees to other direction or not?

    somebody have experience about AFF?
    My target is with AFF run on 7000feed but before like 1inch from corner the feed reduce to 1000mm\min. and after out of corner speed up again.
    so get out realy smooth movement without bump on high feed speed.


    Thanks Tom

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Fadal AFF feed forward question-fadal1-jpg   Fadal AFF feed forward question-fadal-3-jpg   Fadal AFF feed forward question-fadal2-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Fadal AFF feed forward question

Fadal AFF feed forward question