Where do you Get Boards Checked?? - CNCzone.com-The Largest Machinist Community on the net!

chipsahoy · #1 02-04-2007, 06:55 PM

Hi All

Where do you Get Boards Checked??

link if possible..

Chips

hsmexpert · #2 02-10-2007, 10:32 PM

go to uptimecnc.com
they are the best. they know what they are doing and have the best prices and inventory.

bigfishmeister · #3 03-15-2007, 12:03 PM

Also try Omega Electronic Board Repair, Arlington Texas

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Open Source Boards Available, Stepper Drivers and Break Out Boards	pminmo	Open Source Controller Boards	762	11-21-2011 11:51 PM
breakout boards	Gads	General Electronics Discussion	2	03-05-2006 06:39 PM
Anybody ever checked out BiSlide?	devers6	Linear and Rotary Motion	0	12-08-2005 10:09 PM
help with boards	mocnc	General Electronics Discussion	15	02-17-2005 09:18 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)