Deep Engraving


Results 1 to 2 of 2

Thread: Deep Engraving

  1. #1
    Member
    Join Date
    Jun 2016
    Location
    United States
    Posts
    57
    Downloads
    0
    Uploads
    0

    Default Deep Engraving

    I need to use the engraving subroutine to cut through 1/4" steel plate to make stencils. I have the basic program running fine, now need to figure out how to increment it down thru the plate. I need to go about .01/pass.
    Is there something I'm missing in the L9201 engraving cycle that will do this?
    Can the L9201 run in G91 mode so I can increment it down by running It multiple times? Maybe put an "Lx" word on the line?
    Run it in a subprogram?

    Similar Threads:


  2. #2

    Default Re: Deep Engraving

    im sure you can re position in absolute and then return to g91 run in a sub



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Deep Engraving

Deep Engraving