looking for a good place to get axis amp card - CNCzone.com-The Largest Machinist Community on the net!

Nilad · #1 09-08-2006, 10:44 AM

Hi, I am looking for a Y axis card for my VMC15
can any one help?

Thanks,

arizonabrian · #2 09-08-2006, 12:14 PM

Nilad,

Try Kmac they should have it. Look on this site for the phone number
www.DynamicLocator.com/dir

Fudd · #3 09-12-2006, 11:23 AM

The guys at Kmac helped me trouble shoot my Amp card to determine it was bad. They are great. They did not have any cards though, but still helped me. I had to get mine from Fadalcnc.com. They only had one reman. one and no new.

Thanks,

Scott

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)