Got not one, but two 6030s with a gremlin.The offset value (fixture or tool) will, without anyone's help, place a < symbol where a decimal point was. There isn't even a key to enter that on the keyboard.Got a .25 hole in a fixture where there shouldn't be, because it will even happen while running. Anybody?
An update to this 'gremlin' is that the < symbol only appears (when it does) after the number '2'. It may leave some offsets containing a 2 alone, but others it will immediately follow. The decimal point is still there. Example - 2<.032. Any help ?
Suggestions:
- Reinitializing the memory.
- Remove and re-seat the memory expansion board several times to clean the contact pins.
- Clean the processor board back plane pins with a pencil eraser.
Reply with Quote
corrupt offset table
Re: corrupt offset table
Posting Permissions
