I have a Fadal 6030 with the 32MP control. We just had the backup battery fail on the computer motherboard and replaced it. Everything is operating normally except that the "CNC Memory to Disk" will not work. Files still go the other way just fine.
After it transfers 200 or so lines of code the following error pops up......
Error 156....No Response from CNC....
Could there be a setting I am missing????
I was going to reseat the board and connectors to see if I had a bad connection.
It is possible that I broke a wire or something too. Any suggestions on where to look?
Since you can go one way at all syas that the settings are fine. You are having an issue either with the 103 board in slot #8 of the card cage or a problem with the RS-422 in the 32MP. Don't ignore the cabling that goes from the RS-422 back to the 1030 as that could also be a source of the issue.