Was doing some Engraving and the machine stop's and the program goes back to the beginning.. I re cold started the machine.. Made the program smaller, and still haing the same problemm .. All other functions seem to be fine..
So I go back and run a previous program and the machine runs fine.. Does all tool changes and no sigs of any activity.. Is it just a fact that the old controls dont like big programs that are associated with text engraving??
All the fans and everything seem to be working.. Is this a sign of the Vector Drive going out or can I enjoy my weekend??
Sometimes we are our worst enemies.. I ran a previous engraving program that is "BIG" at least for this machine .. It ran fine.. I wish I had a newer control so that I could do a "GA" on the simulation and prove before I ran.. It is looking as though the fault is in the program..