Bad Z or R value in canned cycle

[KevinV_MEI]

Just started getting this error and machine faults. Post the program, load into controller via USB reader camtrol and this message pops up

"Bad Z or R value in Canned Cycle"

There have been no changes to the post or programs and I'm absolutely stumped...

%
O0001 ( 3 )
( CREATED ON 04-20-12 AT 8:13 AM )
( MCX FILE - \\SERVER1\CWF\MEI1117-A123PRODTOOL\WORKSPACE\TOOL2\501-2.MCX )
( NC FILE - F:\3.NC )
( MATERIAL - ALUMINUM INCH - 6061 )
G20
G0 G17 G40 G49 G80 G90 H0 E0 Z0
( 1/4 CENTERDRILL TOOL - 1 DIA. OFF. - 1 LEN. - 1 DIA - 0.25 )
T1 M6
G0 G90 S3000 M3 E2 X1.1379 Y-.28
H1 Z2. M8
G83 G98 X1.1379 Y-.28 Z1.3542 R0.1 Q.1 P.1 F3.
X1.2568 Y-.595
G80
M5 M9
G90 H0 E0 Z0. X0. Y0.
M1
( 11/64 DRILL TOOL - 7 DIA. OFF. - 7 LEN. - 7 DIA - 0.1719 )
T7 M6
G0 G90 S2500 M3 E2 X1.1379 Y-.28
H7 Z2. M8
G83 G98 X1.1379 Y-.28 Z-.1 R0.1 Q.1 P.1 F4.23
X1.2568 Y-.595
G80
M5 M9
G90 H0 E0 Z0. X0. Y0.
E0 X0 Y0
M2
%

Help customer waiting on repair.

[Tedger]

H1 Z2. M8
G83 G98 X1.1379 Y-.28 Z1.3542 R0.1 Q.1 P.1 F3.

I plane is +2.
Drill depth is +1.3542
R plane is +.1
That's a No-No,R plane must be at or above Drill depth.

[txcncman]

H1 Z2. M8
G83 G98 X1.1379 Y-.28 Z1.3542 R0.1 Q.1 P.1 F3.

I plane is +2.
Drill depth is +1.3542
R plane is +.1
That's a No-No,R plane must be at or above Drill depth.

+1

[carbidecraters]

That line should read Z-1.3542

[KevinV_MEI]

It hit me about 30 seconds after I hit the post button.

Thanks all for the help.

Mods go ahead and lock this thread closed.