new in fadal

[ahmed4040]

dear all,

i'm new in fadal..... i can move my 1992 vmc4020 (CNC88HS) in MD mode easily.

i need to type several commands in MD mode and run these command together.

EX: in Fanuc i can type as following:

N10 G90 G17 G80; (then press insert button)
N20 G00 X100 Y100; (then press insert button)
N30 G01 X150 Y100 F200; (then press insert button)
.
.
.
.

finally i can press (cycle start) to run all these commands in MDI mode, now my question is : how to do this way in Fadal (CNC88HS) ??

[denmar]

Go to Pr, star new program, give #, next screen star typing by Inset lines, hit Enter after every line, M2(end of program) or use the LERN Command.

[ahmed4040]

Dear Denmar,

you mean to :
1- press MD then enter (to go to MDI mode)
2- Press PR then enter
3- Press any number for the program (EX: 342)
4- Press IN then enter
5- line in what i need then press Enter after every line

now after doing all the previous, how to run them all together ??

in Fanuc, simply i press cycle start, but in Fadal i do not know what i shall press.

if it possible to describe in details, will be kind.

regards

[ahmed4040]

every time i press AUTO, i get a message "check way lube"



what shall i do tomoperate in AUTO mode

[DareBee]

Fill the waylube tank.

[ahmed4040]

it's filled, also the air pressure is 6 bar and spindle cooler tankmis ok.

i got this message when i press Auto:

Check Spindle Lube, Way Lube and Air Pressure

[denmar]

Hit Start few times

[ahmed4040]

@ Denmar:

i did (hit start few times) but i got the same message .... check the lube.....