Wheel Puller - CNCzone.com-The Largest Machinist Community on the net!

TCAJAX · #1 10-20-2005, 12:05 PM

Does Any One Know Where O Can Get A Wheel Puller, And Pilot Tool To Open Up My Fadel?

Thanks

mxtras · #2 10-20-2005, 12:26 PM

MSC has pullers. Your local supply house should, too....?
http://www1.mscdirect.com/CGI/N2DRVSH

Scott

nervis1 · #3 10-20-2005, 12:42 PM

I have a CAD model for one if you want to make your own.

I eneded up using a gear puller from a local hardware store, cost was 12 bucks.

The pilot tool can be had from the factory or CNCpros.com.

widgitmaster · #4 10-20-2005, 01:12 PM

That type of puller is a standard automotive tool, available at any auto parts store! Commonly used to remove steering wheels!
Eric

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)