Results 1 to 5 of 5

Thread: Play in X Axis Table

  1. 10-29-2011, 10:09 PM #1
    WeTDrEaM
    WeTDrEaM is offline
    Registered
    Join Date
    Feb 2011
    Location
    USA
    Posts
    30
    Downloads
    0
    Uploads
    0

    Question Play in X Axis Table

    Hi, We just noticed that there is a bit of play in the X Axis table. Is there an adjustment for this or does something need to be replaced??

  3. 10-29-2011, 10:20 PM #2
    LouF
    LouF is offline
    Registered LouF's Avatar
    Join Date
    Sep 2011
    Location
    USA
    Posts
    1,089
    Downloads
    0
    Uploads
    0
    What kind of machine do you have?

  4. 10-29-2011, 10:34 PM #3
    WeTDrEaM
    WeTDrEaM is offline
    Registered
    Join Date
    Feb 2011
    Location
    USA
    Posts
    30
    Downloads
    0
    Uploads
    0
    it is a VMC20

  5. 10-31-2011, 07:38 AM #4
    DareBee
    DareBee is offline
    Monkeywrench Technician DareBee's Avatar
    Join Date
    Jan 2004
    Location
    Stratford, Ont. Canada
    Posts
    2,977
    Downloads
    0
    Uploads
    0
    Need to adjust the gibs
    www.integratedmechanical.ca
  6. Register to remove these Ads!

  • 10-31-2011, 11:55 AM #5
    denmar
    denmar is offline
    Registered
    Join Date
    Jul 2009
    Location
    usa
    Posts
    311
    Downloads
    0
    Uploads
    0
    Check Ball screw trust bearing and nut.

    • « Fadal VMC Setup Questions | CNC88 - Runaway Y axis »

    Similar Threads

    1. Play on X axis
      By Peat in forum Cincinnati CNC
      Replies: 0
      Last Post: 10-28-2011, 06:45 AM
    2. Rotary Table play
      By bmurph in forum General Metalwork Discussion
      Replies: 3
      Last Post: 08-06-2011, 07:40 PM
    3. Is there a way to take play out of Z axis?
      By aadrew10 in forum Haas Mills
      Replies: 10
      Last Post: 06-10-2011, 02:16 PM
    4. Play in Table
      By strohkirchw in forum Taig Mills & Lathes
      Replies: 2
      Last Post: 12-31-2010, 07:15 PM
    5. Z axis Leadscrew play
      By Smackre in forum Linear and Rotary Motion
      Replies: 8
      Last Post: 05-07-2006, 11:37 PM

    Posting Permissions


     


    About CNCzone.com

      We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

    Recommended Links

    Quick Links

    Follow us on

    Facebook Dribbble RSS Feed


    Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.