A axis direction change?

[Neal]

Neveris1--
Depending on which version controller card you have the directional change can be acomplished by a simply jumer change. The -6 cards have a jumper setting at J4 (i think) jumper block that allow reversals. If its earlier, let me know and I'll find out what to change.
Neal

[nervis1]

Yes it is a -6 card. Do you know exactly what I need to do with J4?

I don't see it in the manual (may have missed it though, I'll look again). Thanks for the help Neal.

[Neal]

Nervis--
Look on the board itself. Locate the jumper block at J4. It will have the jumpers for X, Y, Z and A axes and spindle. On one end of that block is Rev Dir. Place a jumper on the REV DIR pins. Also on the 1010 controller card there are two wires that go into the small black connector on the edge of the board. Reverse these wires as well. Deed Done.

Neal

[Sibole]

Originally Posted by ZachB Iam not sure if iam reading question right, but I usually use a positive A or negative A value to make our 4th Axis rotate eather direction. And if my post is posting the opposite of what I want, I usually mass modify A to A-. Forgive me if iam way off on this subject. Z

Exactly

[ZachB]

Search and replace just for indexing would work but, true 4 axis machining he wouldnt be able to just change positive and negative values on the A axis. It would seem like your post processor could be edited to do what ya needed tho.

Z

[nstaley]

Have you tried A- or A+

[nervis1]

Read the responses from Neal, he had the answer as usual.