Numatix cutter compensation issue

[carbidecraters]

1. When programmed with Cutter comp. and an arc on -arc off move it will sometimes skip the contour and only perform the arc on-arc off move.
2. On the Numatix you have to use the Feed overide to control both feed and rapid.
3. Numatix does not display code.

Geez doesnt sound like a good sound upgrade for anyone based on these faults it sounds more like a disaster waiting to happen. If these problems were addressed then maybe we would take another look but based on these three things why would I want this control other than if we were only ever doing long contour programs for hours. We already test our colision in Mastercam but...

[Scott_bob]

Question for Numatix users:

Anyone ask if they have the upgrade tested from version 4.2 to version 6.11?

NCPLUS 2000

Afterall these updates were done by the creator (Numeryx) of their software...