| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fadal Discuss Fadal machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-23-2010, 01:09 PM
| |||
| |||
At the end of the program I am getting the error message "Spindle would not stop". then if I try to run the program again I get the message "Inverter Fault" and "Amplifier fault on Axis C" Can anyone tell me if this is a mechanical or electrical problem? The machine is a VMC 3016 Built 1995. Thanks Steve Seattle WA  |
|
#3
07-23-2010, 06:29 PM
| |||
| |||
sounds like the regens are not working ohm wires r1 and r2 coming out of the drive and compare them to what is in the manual,most are around 10ohms also check the large fuse in or around the drive. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SPINDLE DOESNT START AT G97 S600 M3 | Jedi | Haas Lathes | 12 | 08-18-2009 12:57 PM |
| eliminate start and stop of spindle for short program? | endgrainguy | G-Code Programing | 4 | 06-08-2009 09:06 PM |
| Problem- unidentifiable program stop | Dustin L | Fanuc | 0 | 12-11-2008 06:39 AM |
| Doesnt load all of the program? | dafowfidy | Mach Mill | 3 | 08-06-2008 08:00 PM |
| Stop/start a program | jimglass | TurboCNC | 3 | 06-10-2003 08:59 AM |
| | |
Linear Mode
