Help with EnRoute - CNCzone.com-The Largest Machinist Community on the net!

BJK · #1 12-13-2011, 07:03 PM

Hi. I have a TEKCEL router coupled with TEKMOV spooler and EnRoute v 3.3.

I am finding it difficult to setup new tools and cutters (I machine MDF and particle board).

The problem is do not find the interface to be very clear or intuitive when it comes to creating/setting up new tools.

Has anyone else had this problem? Could anyone make suggestions? Your help would be greatly appreciated.

Regards,

BJK.

CNC Mate · #2 12-15-2011, 01:53 AM

i have enroute4;

i think, it is easy to do and the visibility good, about setting up tools is ok too.
May be you should invest in more training.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Enroute Pro 4	Grant Nicholson	General CAD Discussion	7	01-26-2012 08:34 AM
I use Enroute	DIY'er	EnRoute	12	09-21-2009 04:16 PM
Enroute 4	Jorge L Perez	Spanish CNCzone	0	05-22-2009 01:01 PM
Enroute anyone?	trooper55	General CAM Discussion	1	05-26-2008 09:58 AM
Anyone using Enroute	CNCadmin	General CAM Discussion	0	05-28-2003 12:08 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)