feed rate % rpm

[jovanifive]

hello
good morning
thanks for replying and sharing
I have a question for you
I want to make a sample
a 3D texture
I have a multicam 3000
sample is 4x8ft
and I have a bit Onsrud 52-280 of 1 / 4

I have no experience in this type of cuts
I can advise that speed and rpm parameters I can use

[MCPservice]

To create a 3-D texture you are going to have to change your bit to a ball nose bit, second what type of material are you going to be cutting for this sample texture.