Help needed for making an Enroute file - CNCzone.com-The Largest Machinist Community on the net!

Lskov · #1 06-15-2010, 05:25 AM

Hi all Enroute users!

We do have Enroute Pro, however, we are not very familiar with using the 3D capabilities.

So my problem is that I need to make a piece wich is enclosed in a PDF file. (1:1)

Is there anyone out there who could help me on my way here?
(Please excuse my bad english...)

Greetings from Norway

-Lasse-

whipper · #2 07-05-2010, 12:40 AM

Hey, do you need the drawing or drawing and tool path?

Lskov · #3 07-05-2010, 01:17 AM

Hello!

Thanks for Your reply.

After some trial and errors we made this enclosed file wich was perfoect for this job. Maybe we could have done it another way, but the result was perfect.

-Lasse-

whipper · #4 07-06-2010, 12:42 AM

Glad you got it done. Good luck

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
need help with making a cad file	cloverfield333	Solidworks	3	08-20-2009 11:08 AM
i need held in making a MasterCam X3 file.	cloverfield333	Mastercam	4	03-02-2009 08:23 AM
i need held in making a solidworks file.	cloverfield333	Solidworks	18	02-14-2009 10:53 AM
Need help in making a solidworks compatible file	brianklein	Solidworks	16	05-26-2008 08:32 PM
enroute pro 3.3 post for fanuc 0Mb needed	goodplastics	General CAM Discussion	1	08-07-2007 11:47 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)