| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Engraving Machines Discuss Engraving Machines here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-18-2009, 08:11 PM
| |||
| |||
I have V3400 engraver and the power supply board is bad. Can not find adequate replacement due to ratings. If someone has an old EP module that has a good power supply I would be interested. Thanks Scott bamapiney@hotmail.com Power supply- International Power Sources 115/230VAC in Quad output +5VDC 15a +12VDC 5a -12VDC 0.8a +24VDC 4a  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3 NEW KELING-4030 MICROSTEP DRIVERS AND BREAKOUT BOARD,+5V POWER SUPPLY | heilcnc | EBAY ADS | 5 | 09-27-2009 08:01 PM |
| Need Help!- Mazak Power supply wanted. | Al_The_Man | Want To Buy...Need help! | 2 | 09-09-2009 12:26 PM |
| DIY Controller Board Power Supply | Fish4Fun | Open Source Controller Boards | 5 | 03-29-2007 03:43 PM |
| 30v dc power supply for the xylotex board? | ljoe1969 | General Electronics Discussion | 3 | 01-18-2006 08:50 PM |
| Any recommendations for a power supply for their 3 axis board? | ljoe1969 | Xylotex | 8 | 11-05-2003 03:39 PM |
| | |
Linear Mode
