Casmate Lite

[jknoflicek]

I am looking for a dongle for Casmate lite and drivers for a new hermes 7900 engraver. There is apparently no such thing as support anymore so I'm looking to see what's out there

Thanks for the responses.

Jim

[CAD_HANA]

Jim,

Did you ever find a solution to work with your New Hermes?

[jknoflicek]

Sort of, yes.
I have to remove the dongle from one computer to the other -- which is the worst of it.
Within Casmate Lite there is a place where you can change the settings of the table. It uses the same drivers as a 3400 but you need to redefine the table size -- which must be smaller than the actual working size so -- a 12x20 table you would set for something like 11.99x19.99.

In addition your work area must be smaller than the set table size so:
11.985x19.985.

I have had very good success with these settings. You may have to slow down the spindle lowering speed at the EP unit.

Hope it helps.
Still wish I could find another dongle...