SINGLE LINE FONT - CNCzone.com-The Largest Machinist Community on the net!

xxshuaxx · #1 11-29-2007, 08:43 PM

I just purchased the Enroute program to use for engraving, unfortunetly it does not seem to have a single line font and my letters are only .125 inches high so the available fonts are out of the question. Enroute says you can use any True Type font installed on the computer, so where do I find a single line font for Enroute?

I also have an older Gerber machine/program that has single line font on it but it is in a .gsp format. If there is a converter that would convert .gsp to true type font that would also work.

CNCRim · #2 11-29-2007, 11:05 PM

Stick front is what you are looking for, you try import from Microsoft word it Eruoo let you.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Single line font plt creator	Frost	Engraving Machines	0	08-18-2007 08:06 PM
Single line fonts	ccu	General CAM Discussion	2	09-12-2006 07:09 PM
single line fonts?	balsaman	General CAM Discussion	12	02-18-2006 12:51 PM
"Fancy" single line font	DAB_Design	G-Code Programing	20	04-25-2005 04:04 PM
Single Line Font?	squarewave	Carken Products (Deskam, DeskCNC etc)	9	11-29-2004 07:03 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)