Anilam M control - CNCzone.com-The Largest Machinist Community on the net!

Mark M · #1 09-26-2007, 09:21 PM

Anybody out there using this control. I need to get mine worked on. Thanks, Mark.

rudise · #2 03-30-2008, 02:06 PM

I can help, where are you located?

MrWild · #3 03-31-2008, 01:47 AM

Yes, I'm using one. What are your problems?

puller482 · #4 05-23-2011, 11:37 AM

Hello,
I need help with a Crusader M. I have a Republic Lagun with this control. I was running the machine last week and all the servos die at once. I call a CNC repair guy when he checked it out he said the power supply that changes the 110 to 24 volts was bad. He replaced it but the servos still will not fire up. He charged me $600 and left. I found that the Z axis is not reading on the screen and a couple of times we got a red light on the Z axis drive card. A bit more to the story, before it quit and for sometime now the CTR screen would go blank. When it was on it was bright but, now it is very faint and does not want to light up. You have to tap on the cabinet to get it to flash. The X and Y are reading and we switch the plugs for the X and Z on the board in the controller. The Z axis would read when I moved the X but the X would not move when I moved Z. I really need this machine and like it but I am not a repair person when it comes to controls. Can anybody help me.

puller482 · #5 05-23-2011, 11:39 AM

Hello,
I need help with a Crusader M. I have a Republic Lagun with this control. I was running the machine last week and all the servos die at once. I call a CNC repair guy when he checked it out he said the power supply that changes the 110 to 24 volts was bad. He replaced it but the servos still will not fire up. He charged me $600 and left. I found that the Z axis is not reading on the screen and a couple of times we got a red light on the Z axis drive card. A bit more to the story, before it quit and for sometime now the CTR screen would go blank. When it was on it was bright but, now it is very faint and does not want to light up. You have to tap on the cabinet to get it to flash. The X and Y are reading and we switch the plugs for the X and Z on the board in the controller. The Z axis would read when I moved the X but the X would not move when I moved Z. I really need this machine and like it but I am not a repair person when it comes to controls. Can anybody help me.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
help repairing Anilam Crusader II control?	wddanie	Bridgeport and Hardinge Mills	9	09-23-2011 11:42 PM
Any experience with Anilam 3300MK control?	CNCBoss	General Metal Working Machines	4	02-16-2011 08:01 PM
Anilam 3000M Control Users.	Mike Mattera	General CNC (Mill and Lathe) Control Software (NC)	4	07-02-2010 11:28 AM
Anilam M control	Mark M	General Metalwork Discussion	0	09-26-2007 04:44 PM
Looking for a UG NX4 post for an Anilam 1100 control	Tom McMahon	Post Processor Files	1	11-04-2006 05:07 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)