| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Engraving Machines Discuss Engraving Machines here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-03-2011, 05:03 PM
| |||
| |||
Hello, I am in hopes that someone here is familiar with the Hermes Vanguard 7000 Engraver. I am having problems with the spindle motor in that It will not sustain any quantity of load whatsoever, and will not start revolving without a spin-assist by hand. With the belt attached between the motor and spindle it will not turn even with a hand-spin assist. There is no capacitor attached to the motor and I am in hopes that someone is familiar enough to know if there is one somewhere inside the machine, or maybe a relay of some sort. If there is not then I can at least say that the motor needs replacement. Thanking you in advance, gda  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hermes Vanguard 7200 Engraving machine | samco | Engraving Machines | 27 | 11-16-2011 01:47 PM |
| New Hermes EP controller module Vanguard 3000 - LT | engravingnewbie | Engraving Machines | 1 | 11-14-2010 10:43 AM |
| FA: New Hermes EP Unit for Vanguard Series Engravers | joe-electro | Engraving Machines | 0 | 04-21-2010 07:41 AM |
| Newbie- Just got a new hermes Vanguard 7000 | 57phillip | Engraving Machines | 0 | 07-24-2008 09:09 PM |
| Hermes Vanguard 1219 to run on PC ? | RiverGeek | Engraving Machines | 4 | 03-07-2008 03:50 PM |
| | |
Linear Mode
