New Hermes EP controller module Vanguard 3000 - LT

[engravingnewbie]

Hello all,

I recently purchased a used Vanguard 3000 - LT and an EP control Module. The table and EP control module seem to work fine. I am able to control the table directly through the EP control module. The problem I have is that I can't get my computer to communicate with the EP control module. They are connected using a parallel port. The computer is running Windows 95 and has the OpenSys software. Any help will be much appreciated.

Thanks in advance

[gldf]

Hi,
Try to print an hpgl plot file to the LPT1 port.

Regards

Gil