Need Help! finding Gravostyle Software. I have machine & donggle - CNCzone.com-The Largest Machinist Community on the net!

brucef2112 · #1 08-24-2010, 07:39 PM

Hello,
I have a gravograph m40g with its USB donggle and CD software. However the disk is damaged. Does anyone know of a place I can get a copy of the gravostyle software.

Thanks,
Bruce
brucef2112(at)aol.com

Tweakie · #2 08-25-2010, 04:56 AM

Bruce,

I am sure that Gravograph will replace a damaged disc. Have you asked them ?.

Tweakie.

brucef2112 · #3 09-05-2010, 09:00 PM

$57 dollars to Gravograph and I was able to get a copy of the software.

Tweakie · #4 09-09-2010, 06:57 AM

That is a bit steep for replacing a disc.
Gravograph do nothing to improve their reputation with charges like this.

Tweakie.

brucef2112 · #5 09-09-2010, 04:27 PM

Disc? Ohh no. No disc. That was just to download a copy of the software! If I wanted an actual disc mailed to me it would have been even more!!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- acquired CNC router need help finding software and operating manuals	rsharitz	Teachers Hang out	3	08-16-2010 02:48 PM
help finding engraving software	justCNCit	General CAM Discussion	0	01-21-2010 07:02 PM
Finding Engineering Design Software For Automatic Machine Design	hellokitty	General CAM Discussion	0	01-06-2008 12:39 AM
help in finding the best plans and software	temler	DIY-CNC Router Table Machines	1	03-20-2007 05:43 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)