CNCzone Network: RFQwork :: 3Dstuffzone :: Welderzone
I need to have the gantry sides of a router I am building made up as they are just a bit too large for my X2 mill to handle. I would need them made from 1/2" aluminum, and have included the drawings below. I attached 2 drawings per side, 1 is fully dimensioned and the other isn't.
The pieces are the gantry uprights, the left and right side, 1 piece each. All dimensions are in inches. Tolerances +/- 0.001"
Please get back to me with costs and time frame.
Thanks in advance.
This has been awarded.
Thanks to all that sent messages, your help is appreciated.