RFQ small parts needed

[CNC Darren]

I will be needing 22 of these parts made, material either Delrin or aluminum. Note: my cad skills are not the best, if you have any questions abut the part just ask. Its kinda hard to make out in the drawing but the i.d. has a flange on the inside of the bore.

CNC Darren

[kdoney]

My assumptions from your drawing are that you want to take 1.25 inch stock, cut it into .3753 slices, put a hole in it .7504 dia. and have a shoulder of .8660 dia.. You want all of this at .0001 tolerance? How deep is the shoulder (the .8660 cut)? Is the V in the pulley 45 degrees?

[CNC Darren]

the tolerance can be .001
the .866 goes .313 deep leaving a .062 thick flange with an i.d. of .75

CNC Darren

[Ken_Shea]

Maybe this will help

[CNC Darren]

Thats what I need!

I tried to draw it 3D in rhino but about lost all of my hair doing it!! still have to get use to it more.

Thanks Ken!

CNC Darren

[SCOJEN]

Darren,
Email me privately if you have not found a source for your parts and I will give you a quote. Plus what is the angle in the v groove.

Scott

[harolda]

Looks like something made comercially . And modify to yopu spec.