another water/laser rough out

[zcases]

I'd like to see if I could do better on this one by roughing out on a laser or water machine first, then I will just run a single clean up pass if needed and chamfer edges on the mill.

I have attached a DXF of the outline I'd like roughed out. There is only 6 pieces, the sustomer is open to material options, it is basically a go-no-go gauge. And actually aluminum will be satisfactory. I'd like to consider 1/8 aluminum and also a stainless. If the aluminum laser capacity is an issue I will consider thinner. The DXF is the net shape, so if I need to clean up walls, plan on leaving ~.010 or so.

I don't have dims on the dxf but to get the scale, it is 3.875 wide by 3.5 tall.

Thanks all
Scott

[zcases]

Anyone interested in this one?


******** Material Update ***********

Material will now be 3/16 instead of 1/8 ........sorry for any inconvenience.
Scott

[zcases]

This one is closed..........

Thanks for the replies. If this job repeats I will contact those that responded. I milled it in house for this go-round.

Scott