Need A Quote- Lathe job

[gazmalman]

I need a part making for a 5c collet closer im making for my mini lathe. It's too big a part for me to turn in the little lathe!

Basically its a 5c fixture, to be turned in mild steel, drawings here-
closer

Might be better if it was done in the UK as I think it will weigh a bit for shipping, but will still welcome quotes from the US due to the very low value of the dollar.

Cheers!

[snovak240]

PM sent with price. Thanks

[heilcnc]

i would like a quote with shipping on this part to 13838 usa thanks to big for me to turn allso and i always wanted this thanks

[snovak240]

PM sent to heilcnc with price, Thanks.

[gazmalman]

Contract awarded, thanks for all the quotes.

Heilcnc don't forget this is only the holder, you will need something to pull the collet from the back of the headstock. I'm automating it with a draw tube and air cylinder, if your interested I can send you my drawings? Might be good to have someone else having a go at it so we can bounce ideas?