Wood CNC Lathe and 5-Axis router time - CNCzone.com-The Largest Machinist Community on the net!

jolafson · #1 01-02-2008, 06:46 PM

Just an FYI, i havn't seen much in lieu of a need for CNC woodturnings, but we've got a Joker 7000 CNC lathe that we aren't even coming close to it's abilities and would like some challenges to throw at it. It's awesome for small runs of really custom stuff, and we can do some milling as well on the turnings. The router stays pretty busy, but just offering it up for anyone if they're interested.

jolafson · #2 01-02-2008, 07:10 PM

Here's A Picture of The Lathe and the Router, The Router is currently shown working on the indexing lathe end, making curved up-easings for profiled handrail that we make.

bkeys · #3 01-04-2008, 04:03 PM

pm sent

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
4-axis diy router/lathe	skyten	Open Source CNC Machine Designs	7	08-05-2008 12:52 PM
cnc wood lathe	eloid	DIY-CNC Router Table Machines	1	10-08-2007 01:15 PM
Combination 4 Axis router Lathe	wjfiles	DIY-CNC Router Table Machines	3	04-16-2007 06:08 PM
Using a router for the 1st time. Need advice of cut speeds, router bits etc.	Apples	DIY-CNC Router Table Machines	19	09-23-2006 03:33 PM
CNC Wood Lathe	Bucky	WoodWorking	6	03-09-2006 01:22 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)