I need some slots milled in some 14 ga SS.

[Jeff Wohlt]

Would anyone be kind enough to mill some small 1/8" x 1" slots in some SS for me for a hobbyproject with RC boats?

I can mail them to you...I only need about 10 done.

[doughtybrian]

sent you a pm with contact info

[SteelCutter]

14 gage SS (.074" thick) will be very difficult to mill slots on without holding it between 2 steel or thicker aluminum plates, it will wrap around your e-mill otherwise.
Your best bet is to go with laser or water jet!!

Just my $0.02 worth