CNC Milled / drilled logo on wood

[green127045]

I need a "W" drilled out on wood pieces. The wood is about 3/8" thick. Here is the specs and picture

15 piece run
Wood is roughly 9 x 9 and the "W" needs to be centered on the wood and the "W" need to be 4 x 4 inches.
Drilled holes 1/32" in diameter. Apply tape on the bottom side to prevent splinters. I will supply the wood and you mail back the wood when completed....
See picture of how the "W" is suppose to look like...
I would like to see a picture of prototype on scrape wood before running production.

Thanks

James Green

[zcases]

What kind of wood, and how thick is the wood?

[green127045]

Wood is cheap soft stuff and about 3/8" thick. I can change the drill diameter to 1/16" if that helps....

James

[tibbsmn]

How many holes per inch do you want

[green127045]

This is only a company logo so there is no specs on holes per inch. Just make it look good. That's why I ask for a picture of a prototype run before running the production pieces.....

Thanks

James

[dpryor]

James,

I just sent you a PM price.

[MegaMoog]

How bout a Buck-a-piece!
You pay shipping, both ways

[BAD DOG]

Can I Use My 22-250 At 200 Yards?
You Pay For The Bullets

Bad Dog

[Khalid]

free of cost just u pay shipping cost

[tibbsmn]

Originally Posted by green127045 I need a "W" drilled out on wood pieces. The wood is about 3/8" thick. Here is the specs and picture 15 piece run Wood is roughly 9 x 9 and the "W" needs to be centered on the wood and the "W" need to be 4 x 4 inches. Drilled holes 1/32" in diameter. Apply tape on the bottom side to prevent splinters. I will supply the wood and you mail back the wood when completed.... See picture of how the "W" is suppose to look like... I would like to see a picture of prototype on scrape wood before running production. Thanks James Green

James,
I Could do this with my Rotary Engraver, my concern would be that 1/32 holes would not show up that well

I could also do this with my laser engraver not have to go all the way thru the wood and I would just burn dots instead of drilling holes

either way $3:00 a Piece and you pay shipping both ways

Dustin

[green127045]

Thanks for the quotes and the job has been awarded.

Thanks again

James Green