Who has a water jet? - CNCzone.com-The Largest Machinist Community on the net!

fastolds · #1 10-21-2007, 07:00 PM

I may have a need for some aluminum parts from 1/16" to 1/4" thick parts cut on a water jet if cost effective.

rustamd · #2 10-21-2007, 11:09 PM

have you tried http://www.bigbluesaw.com/ yet?

WILLwork4money · #3 10-22-2007, 06:22 AM

How many pieces will you be needing?
what do they look like?
post a pdf or jpg just to give us an idea!

fastolds · #4 10-22-2007, 09:13 PM

One piece is 1/16" thick, 1" wide, 24" long and has a radius. Picture the mouth on a smiley face and you have it. Add 3 small slots also. Quanities could range from 10 Pcs and up.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Water cut??	Yepez	CNC Plasma and Waterjet Machines	8	02-24-2010 08:23 AM
Water transfer techniques for water table?	Knut	CNC Plasma and Waterjet Machines	3	02-02-2007 09:52 AM
Water Jet? Which Pony would you bet on?	JerryFlyGuy	CNC Plasma and Waterjet Machines	13	11-12-2006 09:46 PM
Just add some water to the chips...did you add some water to the chips	carbidecraters	Fadal	13	02-03-2006 11:53 AM
looking for water jet in LA	the4thseal	Employment Opportunity	7	11-14-2005 06:58 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)