RFQ - Rifle Sight

[Flatnick]

Hello

I'm looking to have about 50 replica sights made for an old muzzleloading rifle model. The sight I want to copy is pictured below. The sight is basically an angle iron with a through hole for a pin. I do not need the four sight notches as seen on the picture.



To give you an idea of the dimensions:

The long blade is 1.5" long and .78" wide.
The short blade is .7" long and .78" wide.
Pin hole diameter: .12"

Is anyone interested in this job? I can draw a CAD drawing with measurements of the sight.

Thanks

[Arty 3000]

Pm Sent

[Fegenbush]

PM sent

[AMW]

Hello, thank you in advance for the opportunity to bid on your RFQ

We have sent you a PM requesting your files!

regards

[Flatnick]

This job is now taken.

Thanks

[Flatnick]

The sights have finally arrived. Unfortunately, 50 % of the sights I paid for were missing, and the quality of the ones that arrived was poor. Some of the sights were even useless. The person that made them all of a sudden stopped answering my emails when I tried to ask what has happened. Well, another lesson learned, and money out of the window.

I would like to point out that none of the ones that answered the RFC in this thread are to blame. The person sent me a PM about the job. I don't know whether if it is appropriate according to the forum rules to name the con-man, but I would not hesitate to warn people about this person.

[WILLwork4money]

http://www.cnczone.com/forums/machinist_feedback/

Follow the above link, it will take you to where one can leave FEEDBACK as seen adequate about Buyers / Suppliers / Forum Members etc. etc...

I myself would like to know of any SCAMMERS out there!

[erd39030]

Yeah!
Publish his name, and all data you have about him.
Scammers names have to be public. They hurt all of us trying to do good bussiness here.

Saludos:
Everardo Rascon

[Jarwalcot]

Give Gary at masterpiecearms.com a call. They can help.

Good luck,

[Flatnick]

I'll give him until Wednesday. There is no doubt that he reads this thread because one hour after I posted my last reply to this thread I got an email from him. I doubt that he will pay though. He has about 28 hours.

[mc-motorsports]

You REALLY need to report this person regardless. I have some lathe work that I wanted to RFQ in the next week or so, yet after reading this I may be hesitant. It's not good for you, it's not good for me, and it's not good for the potential suppliers on cnczone.com

[erd39030]

The sights look pretty easy to make... am I wrong?

how did he managed to scrap most of them?
what he used? a hand saw and a file?