RFQ: Several parts - CNCzone.com-The Largest Machinist Community on the net!

mothman · #1 04-26-2007, 12:18 AM

Let me know if any of you would like to machine this parts. I need two pieces for design 1 and 2, 4 pieces for design 3 and one parts for design 5-7. For design 1, I will send you 5mm 7075-T6 aluminum and 6061-T6 sheet for other parts. Sorry for the small quantity, but this is a prototype for a school project. Please let me know the price and when can I expect to receive the parts.

Thanks

ltmquik · #2 04-26-2007, 12:22 PM

Any chance of getting some drawings with dimensions? Basic would be fine so I could a least figure the scaling, if any, of the part.

mothman · #3 04-26-2007, 12:25 PM

Sorry for the confusion, the intended unit on the 1st design was in mm and the total length of the parts should be around 338mm.

mad mark · #4 04-26-2007, 03:25 PM

Can the sharp inside corners have any tooling radius at all??

machZ · #5 04-30-2007, 02:40 PM

I Would Like To Quote On These Parts,but I Will Need Dimentions
And Tol. For Each.
If There Is Any Tapped Holes Or Reamed Holes On Any Details?

Thanks

Cadwhiz · #6 05-01-2007, 06:17 PM

I would like to quote also, with same reservations as machZ, I need dimensions and tolerances to each.
Thanks,

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need a few parts (RFQ)	CNCadmin	Employment Opportunity	4	09-28-2005 12:20 AM
Where can i buy an Kit/parts of an CNC?	samsagaz	DIY-CNC Router Table Machines	6	08-16-2005 10:40 AM
Parts need... Any help??	debutis	Parts for Radio Control Models	10	08-05-2005 12:01 AM
RFQ 20 parts	impact	Employment Opportunity	13	04-18-2005 08:20 AM
RFQ - SRC Parts	Swami	Employment Opportunity	1	03-25-2005 09:14 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)