Any of you want to do me a favor?

[Cold Fusion]

I need two of each of these machined. 1/2 inch aluminum, 6061 would be best. I can have the metal shipped to you or I can pay you to buy it local. How much is this going to cost me if one of you machines it? I can pay now and wait up to a month. Parts are approx. 5x24 and 14x4. Thanks!

Side
End

[CNCadmin]

can you post a screen shot ?

[Cold Fusion]

End is 24x5 with .2 deep counterbored holes.

[Cold Fusion]

Side is 14x4 with counterbored holes for my linear shaft that are .2 inches deep and a .1 inch deep pocket for the pillow block face.

[CNCadmin]

You only need one of each?

[Cold Fusion]

2 of each piece.

[CNCadmin]

Sent you a quote, do you have a autocad drawing of the parts?

[Cold Fusion]

YGPM with a link to the dxfs and well as a picture of the whole router.