RFQ: Lathe work, one piece. - CNCzone.com-The Largest Machinist Community on the net!

SCCoupe · #1 07-23-2006, 11:54 AM

Need a quote for the attached part. Made of aluminum. I will send the bearing for the slip to fit surface. Need just one.

M-man · #2 07-24-2006, 03:00 AM

I could make that piece, but I guess the shipment from sweden will cost a bit.

SCCoupe · #3 07-24-2006, 05:58 AM

Work is in progress. RFQ closed.

M-man, shipping could have been cheap. I work for Volvo and know quite a few people in Skovde, Koping, and Gothenburg that could have brought it with them to the states. I also make it over to Sweden for training once in a while.

Maybe next time, thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)