RFQ 34 - Small manual job - Offset turned and cross drilled hardened locking pin

[InspirationTool]

RFQ 34

Description: Offset locking pin turned and milled from 5/8" steel.

Material: Pre-hardened steel supplied by job shop.

Features: Offset section turned down to .500" on one end. Cross drilled and reamed hole .251", and 1/4-20 tapped hole on the other end.

You will need a lathe and mill for this job, manual okay.

Quantaties: Please quote 1, 10, & 20.

Please e-mail jeff@inspirationtoolworks for full RFQ document and drawings.

Thanks!

-Jeff

[InspirationTool]

Thanks! The quote has been awarded.

If things go well, you'll see the part on E-bay!

-Jeff

[InspirationTool]

Okey-dokey....

Two shops have tried to make these and were unable to make them to specifications. The issues are the +0 -.001" OD tolerances, the sharp (.015" radius) inside shoulder, and working with hardened steel.

I would like to point out that both shops were honest and up-front with me about these parts and I am already looking at them for other jobs. Just be honest and we can work everything else out

I'm willing to pay $10 - $15 each on these in quantities of 20.

Anyone else want to take a crack at this, please send me an e-mail.

Thanks!

-Jeff

[InspirationTool]

By the way, 4140 in a hardened but machinable state is good for these.

-Jeff

[mroy0404]

Sure I will quote.

Send prints to mroy7@cogeco.ca

[fuzzman]

We don't have a CNC Lathe, but we have 5 Mazak Mazatrol Mills that would like to quote any and all mill work, if you have any. Thanks.

George

[Derek.C]

I Was Just Wondering Ifthe Job Has Been Done Or Not If Not Email Me And I Will Take Care Of It.

[InspirationTool]

I haven't been replying to e-mails because I've been on vacation... the job has not been awarded yet. I'll catch up next week.

Thanks!

-Jeff

[Rustybolt]

I'd like an oportunity to quote as well. Messege me for an email address.

[InspirationTool]

Hi all!

Thanks for the great response. I should have remembered I was going on vacation before I asked for more quoters. Anyways, I have plenty of people quoting on this. I will respond to everyone who e-mailed me in the next couple of days.

Thanks!

-Jeff