Need A Quote- plasma, laser, waterjet, cut part

[millman52]

Please quote (100), (200), (300) & total quantity from a 48" X 96" sheet of A-36 HR steel plate. Quote from 1/4" thick & 1/2" thick material.

Parts must be free of slag, dross, burrs, etc. This is a part for OEM. Uniform quality & appearance is a must.


Normal edge taper ok. Small hole size is 17/32 Must freely slide over a 1/2" pin.

The inside of the h must be no smaller than 1 1/2" at smallest point. Outside of part non critical +/-.062.

A sample part from each size will be required after bidding ends before award is made.

Please state lead time & shipping rate to ZIP 25164


Bidding closes Jan. 28 2011

[pdjcutandfab]

Originally Posted by millman52 Please quote (100), (200), (300) & total quantity from a 48" X 96" sheet of A-36 HR steel plate. Quote from 1/4" thick & 1/2" thick material. Parts must be free of slag, dross, burrs, etc. This is a part for OEM. Uniform quality & appearance is a must. Normal edge taper ok. Small hole size is 17/32 Must freely slide over a 1/2" pin. The inside of the h must be no smaller than 1 1/2" at smallest point. Outside of part non critical +/-.062. A sample part from each size will be required after bidding ends before award is made. Please state lead time & shipping rate to ZIP 25164 Bidding closes Jan. 28 2011

1

[pdjcutandfab]

Originally Posted by pdjcutandfab 1

See attached.