Need A Quote- Upstate South Carolina CNC wood work

[jofinneg]

I'm not sure if this quote request is too small-time for this forum, but I thought I'd give it a shot.

I'm looking for a quote on some CNC wood work. The Greenville/Easley/Greer, South Carolina area is preferred so I can easily pick-up and drop-off.

The end product is entirely spec, so I could sell 2 or 200.

The initial product will be engraving-type work on about 24" x 7.5" white oak boards. I will provide the stained boards.

I cannot do minimum runs at this time. I would like orders produced as they are received with a reasonable lead time.

I'm able to provide .dxf files or pretty much any graphic file type.

Please reply or pm me to start a conversation about the opportunity.

Thanks,
John

[jofinneg]

I'd like to open this up to everyone, regardless of geographic location.

I'm trying to get a sense of what I should expect to pay on a per piece basis.

Please see the attached for a visual representation.

Sizing is roughly 22" x 7.5" on 3/4"-1" solid white oak.

The white that is shown would be the engraved portion with an ideal depth of about 1/16". If you can visualize a stained board that is engraved to show the raw wood- that is the effect I am going for.

The entire board will be xy cut around the perimeter, and there will be 4 mounting holes drilled through that are not shown on the attached.

Please post a reply, pm, or email me your thoughts.

Thanks,
John